SFX
ATMOSYNTH built-in module
Not a note at all: a sawtooth swept by a low-frequency oscillator through a resonant filter.
Four notes played on it, from a Keyboard, as a patch plays it.
What it is made of
Ports: note input ‘Note’, audio input ‘In’, audio output ‘Out’.
- ‘note’: note input · port midi
- ‘in’: audio input · port in · into ‘tone’
- ‘osc1’: Oscillator · wave sawtooth · into ‘tone’ · detune turned by ‘Detune 1 (cents)’
- ‘tone’: Gain · into ‘filter’
- ‘filter’: Filter · filter type low-pass · into ‘vca’ · cutoff turned by ‘Brightness (Hz)’ · resonance turned by ‘Resonance’
- ‘vca’: Gain · into ‘level’ · level set by ‘Amplitude’
- ‘level’: Gain · into ‘out’ · level turned by ‘Level’
- ‘out’: audio output · port out
- ‘lfo’: Oscillator · wave sine · into ‘sweep’ · rate turned by ‘Sweep rate (Hz)’
- ‘sweep’: Gain · modulates the cutoff of ‘filter’ · level turned by ‘Sweep depth (Hz)’
- ‘Amplitude’: envelope, 4 points, on the level of ‘vca’ · holds at point 3
- ‘Attack’: knob, 0 to 4000
- ‘Decay reaches sustain at’: knob, 0 to 8000
- ‘Sustain level’: knob, 0 to 1
- ‘Release ends at’: knob, 0 to 12000
- ‘Brightness (Hz)’: knob, 20 to 20000 Hz
- ‘Resonance’: knob, 0.0001 to 30
- ‘Level’: knob, 0 to 2
- ‘Detune 1 (cents)’: knob, -1200 to 1200 cents
- ‘Sweep rate (Hz)’: knob, 0.05 to 40 Hz
- ‘Sweep depth (Hz)’: knob, 0 to 8000
No published patch uses this module yet
When somebody publishes a patch built on it, that patch will be listed here.